Home / Product / Granulator Screw & Barrel / Granulator screw & barrel
Granulator screw & barrel
Granulator screw & barrel

Granulator screw & barrel

The screw consists of thread and rod. It has a slot hole along with the center line, which can be used to flow cooling water. The end of the screw is installed inside the thrust bearing, that can avoid the screw being pushed out by the acting force when extruding rubber.

 

Feedback

Granulator screw & barrel Details

Low-price high-quality granulator screw, worth your investment.
The screw consists of thread and rod. It has a slot hole along with the center line, which can be used to flow cooling water. The end of the screw is installed inside the thrust bearing, that can avoid the screw being pushed out by the acting force when extruding rubber.
The diameter of the screw is a little smaller than the inner diameter of the steel sleeve, that is, there should be a gap between the screw rod and the steel sleeve inner surface, and the gap generally is 0.002 to 0.004 times as screw diameter. If the gap is too small, the screw will abrade or even stuck. On the other hand, if the gap is too large, the backflow of the feed will influence the extrusion output, lower production efficiency, and even affect the product quality.
Label: Screw, Barrel

Feedback