Home / News / Industry News / Treatment of power failure in extruder barrel screw operation

Treatment of power failure in extruder barrel screw operation

Update:11-08-2018
Summary:

When the extruder suddenly loses power during normal op […]

When the extruder suddenly loses power during normal operation, if the material inside the extruder barrel is not discharged to the outside in time, some powder coatings will have a curing reaction and a gel, which may even be cured for a long time, resulting in failure to start. It is necessary to heat the material in the extruder barrel with a tool such as electric heating or a gas torch, which is easy to damage the equipment. Therefore, immediately after the power failure, the main switch of the extruder should be turned off, and the extruder motor should be manually rotated by hand belt or with a rocker. The internal materials of the extruder should be discharged as much as possible, so that the residue in the barrel is less, and at the same time A small amount of pure resin introduces part of the residual powder coating material. Since only the residual heat of the extruder can be utilized at this time, the amount of pure resin added cannot be too much.

If some of the extruder's main motor is directly connected to the gearbox and there is no rocker to rotate the motor, the cooling water of the cooling system can be increased, so that the temperature of the extruder barrel and the screw can be quickly cooled down to prevent the squeeze. The material in the machine reacts chemically.

The screw arrangement of the extruder barrel must be determined according to the displacement of the extruder. Different extruders have different requirements.
1. The left and right direction cannot be reversed
2. Center debugging is true
3. According to the product debugging gap to ensure plasticization effect
4. Must be concentric with the distribution box

PREV:       It is the last article